@rupamanoj311 Good afternoon, I've written to you, I've private messaged you again
Can't connect to Fingerprint
-
Every time I start running it gives me an error. After that failed run the next run is normal. I use the latest BAS pre with fingerprint switcher.
I run with 30 threads.
The project logic remains the same. Recently problems started to occur.
-
@hungdaingoc said in fingerprint switcher problem: Failed to get page....:
Every time I start running it gives me an error. After that failed run the next run is normal. I use the latest BAS pre with fingerprint switcher.
I run with 30 threads.
The project logic remains the same. Recently problems started to occur.Most likely, you have problems with your provider
-
In record mode, no error occurs. Only error in run mode.
-
I run 30 threads but only 1 thread is active. When I reduce the number of threads, more tabs are active.
I've been stuck here for hours. At the peak I only got 80 successful attempts and 9000 failures? I tried to put the actor get fingerprint in a loop but it always failed. -
I run 10 threads and it works 100%. But when the number of threads is greater than 10 it doesn't work? Or is your server blocking or restricting my address?
Is no one solving the problem? -
mee too. they don't seem to care about us
-
@hungdaingoc Good afternoon. We are investigating what caused the error.
-
@hungdaingoc
Unable to reproduce your issue.
I received fingerprints from 20 threads, each thread receiving one fingerprint with PerfectCanvas and one without.
As far as I understand, you're getting errors when retrieving fingerprints from PerfectCanvas. I've had similar errors, but it's related to my internet provider blocking access to the servers.
Try using a VPN. You can also use the built-in proxy functionality:
https://wiki.bablosoft.com/doku.php?id=ru:connectionconfig -
This post is deleted!