Bablosoft

How to keep track of Successfully executed threads

Support

  • N

    Execute Code module - how it works?

    Support
    0 Votes
    2 Posts
    483 Views
    FoxF

    @nabil said in Execute Code module - how it works?:

    Main/Tools/Execute code - how it actually works?

    I see it works sometimes with very easy javascript logic, but it failed to do filter/push etc, works fine with devtools, but failed to understand what type of javascript works here always.

    const str = [120, 121]; const match = []; for (let i = 0; i < str.length; i++) { if (str[i] === 120 || str[i] === 121) { match.push(str[i]); } } log(match); // Output: [120, 121] SyntaxError: Parse error during execution of action

    any guideline will be better?

    Thanks

    Don't use "let". The BAS uses an implementation that supports the ECMA-262 standard.

  • D

    Hello, I set 5 thread and It just run 1 thread when I run my script

    Moved Support
    0 Votes
    5 Posts
    824 Views
    D

    @Ajshma Thanks so much

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    783 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • R

    Wait between each thread start

    Support
    0 Votes
    4 Posts
    1712 Views
    FoxF

    @andykaufseo
    0_1540467683083_efe6546f-f329-4acb-a0ff-719abf6943d0-изображение.png
    0_1540467719626_29.xml

  • D

    How : Get new list element in new thread

    Support
    0 Votes
    2 Posts
    1764 Views
    supportS

    @Diya.3rif Need to use reources and set maximum succes number (recomended).
    If you work in one thread and use loop(not recomended), you can unset Reuse recources.

    0_1504114381705_UnsetReuseResource.png