Bablosoft

Fail Reason : Order status is wrong

Support
  • B

    Hello, today I have successfully paid for BASPremium and FingerprintSwitcher (money is charged), but in online shop system says Fail Reason : Order status is wrong... How can I contact administration? No any contacts anywhere!!! If administration reading this, please send me email (same on forum and in the shop).

    FoxF 1 Reply
    0
  • FoxF

    @basdv said in Fail Reason : Order status is wrong:

    Hello, today I have successfully paid for BASPremium and FingerprintSwitcher (money is charged), but in online shop system says Fail Reason : Order status is wrong... How can I contact administration? No any contacts anywhere!!! If administration reading this, please send me email (same on forum and in the shop).

    answered in PM

    0

  • H

    Failed to write engine file

    Support
    0 Votes
    1 Posts
    106 Views
    No one has replied
  • sanyaS

    Failed to get proxy ip

    Moved Support
    0 Votes
    3 Posts
    747 Views
    AngelOfAncientA

    @Alex84 Не работает эта фигня...
    Если её убрать, то ошибка Failed to get proxy IP уходит.
    Но сайт всё равно не загружается, ни один, через Браузер.

  • P

    Error: Failed to set the 'innerHTML' property on 'Element'

    Support
    0 Votes
    2 Posts
    713 Views
    m4zuperM

    @ptt-bds
    Could you provide more details please. Which sites is the problem with and what action? Perhaps you could attach a test project so I can replicate your problem?

  • H

    Start Threads after Status "ok"

    Support
    0 Votes
    1 Posts
    474 Views
    No one has replied
  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    952 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.