Bablosoft

Group id

Support

  • G

    action id

    Support
    0 Votes
    7 Posts
    846 Views
    sergerdnS

    @genericname1 said in action id:

    Can you tell me, where can I find all the available commands like this?

    I suggest that you take the time to periodically review the XML code of your script to understand what BAS is doing when you are using it.

  • hvrshH

    Session with given id not found ERROR

    Support
    0 Votes
    7 Posts
    1166 Views
    Alex84A

    Там глядели, может вообще Заглушка Гугла вылезти, это значит что Прокся не идут.
    На такой случай я проверки её ставлю и ни когда считай не ставлю Полную Загруз Браузера.
    Просто ждать Ссылке этой, она обычно срабатывает, перед открытием - появлением страницы.

    Там уж Таймаут и если Url не загрузился то в Игноре Ошибке и обработать это дело :)

  • A

    InMail.getMessages: Could not find a message matching the specified id in the specified mailbox folder

    Support
    0 Votes
    2 Posts
    598 Views
    J

    @alexjohnhamber12 said in InMail.getMessages: Could not find a message matching the specified id in the specified mailbox folder:

    3 code to get from mails but the last one some time f

    im having the same issue since update to newest module. maybe will switch to old module

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    902 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • A

    Select Database Group ID

    Support
    1 Votes
    25 Posts
    8973 Views
    supportS

    @andykaufseo I didn't read all thread, but here is answer for original question.
    You can insert only to new group, which is created with Create Group action.
    Create Group returns group id, which can be used later inside Insert Record action.

    There will be interface to search/edit/delete groups but later.