Bablosoft

BrowserAutomationStudioProject 24.9.0 not Run My Script.

Support

  • T

    Нужна помощь в настройке DevTools версия 28.5.0 DevTools

    Support
    0 Votes
    9 Posts
    1258 Views
    T

    @Fox Я уже так и делаю. Правда иногда после наведения на нужный элемент, автоматически срабатывает click(), после чего приходится жать back и заново все инспектить.
    А раньше сразу был фокус на искомый элемент, а к хорошему привыкаешь быстро!!! :))

  • K

    Run LOCAL BAS script through external language

    Support
    0 Votes
    8 Posts
    1292 Views
    hellomembershaH

    @Oyasumi-Punpun So the answer to @kingdomtiz question is ultimately no. Thanks for response.

  • B

    Get BAS Script username

    Support
    0 Votes
    3 Posts
    917 Views
    B

    @Fox said in Get BAS Script username:

    There is no such functionality yet.

    Ok, already thought that. Then here with this topic I open an proposal that this could be added in the future. Thanks very much :)

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    902 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • H

    Script Inside Script

    Support
    0 Votes
    1 Posts
    766 Views
    No one has replied