Bablosoft

Failed to wait of state complete

Support

  • R

    element click again when its failed

    Support
    0 Votes
    1 Posts
    354 Views
    No one has replied
  • B

    How to Wait Each Thread?

    Support
    0 Votes
    2 Posts
    527 Views
    E

    @bennettjimmy63 its pretty simple just after Initialize just go on
    Script statics - Thread number OK
    then
    Waiters - Sleep - [[THREAD_INDEX]]*(time to wait ms)

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    783 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • B

    How to Log Data of a Failed Thread?

    Support
    0 Votes
    2 Posts
    1260 Views
    olegtutO

    @babahafti said in How to Log Data of a Failed Thread?:

    If I am running a script and one thread fails, the data used for it will disappear from the source and I cannot see which one has to be reused.

    There is no way to know which data was taken, 'cause the thread had deleted all things used before. But u could log data used before the thread will be crashed.

  • S

    How to auto reload page if thread failed to load url?

    Support
    0 Votes
    5 Posts
    1991 Views
    P

    Im trying to do the same.. am i dong it right?

    ignore errors -> load url while (was_error)-> load url next steps

    Cant check if its right, because i dont know to to fail load url on purpose :)