Bablosoft

Hcaptcha Fails

Support

  • S

    'Too much fails' How to exceed the limit

    Support
    0 Votes
    2 Posts
    495 Views
    FoxF

    @sponkly said in 'Too much fails' How to exceed the limit:

    If the processes in 'Ignore Errors' give an error, the process continues 1 or 2 times, it ignores it, but after a while it gives the 'Too much fails' warning and the script is terminated and the bot stops. how can I overcome this? Even if it constantly fails, it should continue the cycle again each time. I never want it to stop.

    The action always ignores errors regardless of the number of errors, an error in the logic of your script

  • B

    Script stops after 1million success or fail execution. How to increase the number?

    Support
    0 Votes
    2 Posts
    636 Views
    M

    from here select custom
    2022-05-24 07_41_40-Window.png

  • N

    Discord hCaptcha not working

    Support
    0 Votes
    2 Posts
    1022 Views
    NazariiN

    Telegram @nazmel32

  • S

    More than 1,000,000 success/fails?

    Support
    0 Votes
    4 Posts
    797 Views
    S

    Never mind, I had to go into "custom" to see the option. Thanks.

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    952 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.