Bablosoft

Script in record mode working but not in working in thread mode

Support

  • K

    Run LOCAL BAS script through external language

    Support
    0 Votes
    8 Posts
    1199 Views
    hellomembershaH

    @Oyasumi-Punpun So the answer to @kingdomtiz question is ultimately no. Thanks for response.

  • G

    Why the script runs ok in Record mode only?

    Support
    0 Votes
    2 Posts
    517 Views
    NotWegantN

    @givirus its because of your script logic, maybe you dont call the function? OR you dont have proper error handling which results into certain parts of your script being skipped since they are inside an if statement. I encountered this problem many times in the past, you will need to handle errors and it'll will be most likely fixed, for the purpose of debugging you can use the "Log" function at several points to see where it will print it.

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    844 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • D

    The script run incorrectly with run mode

    Support
    0 Votes
    1 Posts
    584 Views
    No one has replied
  • U

    Restart Thread

    Support
    0 Votes
    3 Posts
    1726 Views
    U

    Okay. Thank you very much for help ! :)