Bablosoft

when i execute more 5 threads he all are very slow.

Support

  • E

    Script finished with error : SyntaxError: Parse error during execution

    Support
    0 Votes
    1 Posts
    614 Views
    No one has replied
  • selenagomez2391S

    Data usage per thread

    Support
    0 Votes
    2 Posts
    649 Views
    selenagomez2391S

    @selenagomez2391 hi

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    869 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • nicckN

    Close current thread due to timeout

    Support
    0 Votes
    1 Posts
    536 Views
    No one has replied
  • T

    Threads bug

    Support
    0 Votes
    2 Posts
    1079 Views
    FoxF

    @tombarkley said in Threads bug:

    I have 2 scripts created - one to check proxies can access a site (writes them to file), and another to use these proxies (reads from this file)

    The first script runs fine, I run on 10 threads. When 1 thread ends, it creates a new thread and continues until the file is empty. As expected.

    However the second script runs X threads which is a random number between Y and Z. In this case, when 1 ends another thread is not created. Changing this to a fixed integer fixes the problem.

    I assume this is just a small bug that could be easily fixed, as ideally I would like to have a different num of threads on each run (for time or resource balancing)

    BAS 21.7.2
    Chrome version 68.0.3440.106

    According to the description, you can guess for a long time. Send a script, I will look.