Bablosoft

continue script of someone else ?

Support

  • M

    When I had compiled my test script, I hit Run but kept saying Launching 10% on several computers. How can I solve it

    Support
    0 Votes
    3 Posts
    765 Views
    L

    @marogersr1 Had the same problem and used https://one.one.one.one/ to fake DNS and it worked

  • J

    How can I start a BAS script using nodejs?

    Support
    0 Votes
    3 Posts
    943 Views
    J

    @Fox Oh, I didn't think I could run it as a child process with .exe - thanks!!

  • E

    Script finished with error : SyntaxError: Parse error during execution

    Support
    0 Votes
    1 Posts
    737 Views
    No one has replied
  • N

    Script not run after compile

    Support
    0 Votes
    6 Posts
    1222 Views
    FoxF

    @gboxboss said in Script not run after compile:

    @Fox hi, yes this is thesame issue i am facing, i am using a thirdparty module but it does not work when i compile, what do you mean by create 1 action of this official module, could you please explain

    There may be actions of other modules inside the module, and all modules are active when editing the script. But when compiling, BAS analyzes what actions are in the script, and if there are no actions of any module in the script, then this module is disabled.

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    1003 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.