Bablosoft

failed to init interface. please retry

Support

  • S

    Can we integrate custom interface of BAS with the record mode of BAS?

    Support
    0 Votes
    1 Posts
    686 Views
    No one has replied
  • T

    Help Please - geolocation settings or updating precise location?

    Support
    0 Votes
    2 Posts
    681 Views
    O

    @theinvestedmind did you find a solution?

  • selenagomez2391S

    Custom interface

    Support
    0 Votes
    3 Posts
    897 Views
    Y

    I need it too. Is there a sample code for this?

  • M

    "Group of steps" that should be executed if script fails at any point?

    Support
    0 Votes
    4 Posts
    1003 Views
    GaGG

    Not sure what will happen in that case. You can experiment and see what
    happens in such case, and what function will execute in such case.

    On the other hand, if you already use ignore errors on several points
    in the script, Im sure you can write such program logic and decide based
    on error type reported what happens after each ignore error function.

    For example you can write separate functions that executes by calling them
    from ignore error functions. Those separate functions can, for example,
    handle error cases when you want script to stop execution, so at the end
    of function you can explicitely use actions that finishes the script with success
    or with fail message. And in such scenario you dont need to encapsulate whole
    script, but rather controll it with your custom logic on each place you use
    ignore errors function.

    So you can for ex. retry to load page 2-3 times based on ignore errors function
    used in a loop, and if error persist after 2-3 cycles, you can call your special function
    that will terminate script execution after such condition is met.

  • B

    How to Log Data of a Failed Thread?

    Support
    0 Votes
    2 Posts
    1427 Views
    olegtutO

    @babahafti said in How to Log Data of a Failed Thread?:

    If I am running a script and one thread fails, the data used for it will disappear from the source and I cannot see which one has to be reused.

    There is no way to know which data was taken, 'cause the thread had deleted all things used before. But u could log data used before the thread will be crashed.